Power Connections - Pyle PLXR3B User Manual

POWER CONNECTIONS

USE AN IN-LINE POWER FUSE(3 Amp)
WITHIN 12" OF THE BATTERY
(NOT PROVIDED)
RADIO'S REMOTE
TURN-ON OUTPUT
Head Unit
BATTERY
IMPORTANT!
Before making any connections, disconnect the car's battery until the installation
is completed to avoid possible damage to the electrical system.
Connect the Power terminal of the crossover to the car's battery.
Use a 16 gauge wire to connect to the terminal on the crossover marked +12V.
Run the wire directly to the positive terminal of the car's battery. Make sure to
use an in-line fuse (3 amp) within 12' of the battery. Since the crossover's current
draw is nominal, you can connect to the pre-existing + 12V power wire that has
been run for the crossovers if so desired.
Connect the ground terminal of the crossover to the car's chassis.
Use a 16 gauge wire to connect the GROUND terminal to the car's chassis.
Try to keep the length of the cable as short as possible, preferably less than 12".
Also make sure that the point on the car chassis where the connection is to be
made is free of paint and dirt. It is recommended to use the same grounding
point as the ampli ers to eliminate the possibility of ground loop (engine noise)
caused by di erent levels of ground to each of the components.
6
www.PyleUSA.com