Page 1
ACTIVE CROSSOVERS INSTRUCTION MANUAL 2-way stereo plus subwoofer CHANNEL 1 SUB WOOFER CHANNEL 2 1.7K 1.7K 4.1K 4.1K 30HZ 30HZ 30HZ 30HZ 30HZ 30HZ LOW GAIN LOW GAIN LOW CUT LOW CUT XOVER FREQ XOVER FREQ HIGH GAIN HIGH GAIN PHASE SUB GAIN SUB GAIN...
SAFETY INSTRUCTIONS CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: To reduce the risk of electrical shock, do not remove the cover ( or back ) .No user serviceableparts inside; refer servicing to qualified personnel. WARNING: To reduce the risk of fire or electrical shock, do not expose this appliance to rain or moisture.
TYPICAL SET-UP HIGH AMP LOW AMP SUB AMP CHANNEL 2 AC INPUT 95-120V /210-240V 60-50Hz Rated Power Consumption 6W FUSE: 210-240V: T100mAL 250VAC 95-120V: 200mA 250VAC REPLACE FUSE WITH CORRECT TYPE ONLY HIGH OUT2 LOW OUT2 INPUT2 INPUT2 WOOFER HIGH OUT1 (UNBALANCED) (BALANCED) Non-use Periods:...
CONTENTS CONTROLS CONNECTION CONNECTION CABLES SPECIFICATIONS TYPICAL SET-UP SPECIFICATIONS Crossover Type Crossover Range Filter Type (Slope) Inputs Type Impedance Outputs Type Impedance Low Cut Filters Frequency Response Total Harmonic Distortion (THD) Noise S/N Ratio Fuse Dimensions Weight Stereo 2 ways Subwoofer Subwoofer: 50 - 250Hz, 24/10dB Low/High : 250 - 6000Hz,...
Page 5
XLR-M-JACK unbalanced link LINK 3 to 1 GROUND SIGNAL XLR-F-JACK unbalanced link SIGNAL LINK 3 to 1 GROUND PLEASE READ THIS MANUAL BEFORE OPERATING THIS UNIT Caution : To prevent malfunctioning and/or possible equipment damage: SLEEVE SLEEVE CONTROLS 1 ON/OFF SWITCH Caution: Always turn the Crossover ON before the amplifier, and turn it OFF after the amplifier or transients harmful to the speakers may result.
5 PHASE SWITCHES: These allow switching the polarity to invert the signal phase on the HIGH ways. This is done afterthe output levels are set to correct audible phase problems. Caution: Before pressing the PHASE switches, always lower the outputs of your power amplifiers to avoid possible speaker damage.