Page 1
Specification and Manual Customer: Description: Heater for Equipment (Wall Mounting) Customer Part No.: Rev.: Delta Model No.: HEH080AB Rev.: Sample Date Code: Sample Issue Date: MAY.29 2020 Please send one copy of this specification back after you signed approval for production pre-arrangement...
The document is the exclusive property of Delta Electronics, Inc. it should not be distributed, reproduced, or any other format without prior permission of Delta.
Page 4
Part no.: Delta model no.: HEH080AB Install the heater in accordance with the instructions in this installation manual. Improper installation may result in damage, electric shock or fire. Make sure that all wiring is secured, that specified wires are used, and there is no strain on the terminal connections or wires.
Page 5
Part no.: Delta model no.: HEH080AB This appliance is not to be used by any persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given proper supervision or instruction. Children should be prevented from playing with the appliance.
Page 6
Part no.: Delta model no.: HEH080AB Specification for Approval Customer : Description : Heater for Equipment (Wall Mounting) Customer P/N : Rev. : Delta model no. : HEH080AB Rev. : 03 Sample revision. : Date Code : Sample issue date : MAY.29 2020...
Part no.: Delta model no.: HEH080AB 1. Product Instruction 1-1. General Description The heater is designed for warming up the air in enclosure. It can avoid equipment damaged at lower temperature and water condensation. The heater can be mounted on the wall of cabinet.
Page 8
Part no.: Delta model no.: HEH080AB Key Components Controller Communication port Fans Delta High Efficiency Fan * The Heating capacity (W) is defined as W=V*A at 0 W : power consumption V: Operating Voltage A : Operating current ** Test condition are AC input 115Vac that is cold start at ambient temperature 25 C.
Part no.: Delta model no.: HEH080AB 1-3. Dimension Heaters should be installed at center and low position in the enclosure for optimum heat distribution. Heater can’t be installed on wood or other combustible surfaces. The heater should be mounted in a vertical position with the terminal connect at the bottom and the air outlet at the top as shown.
Part no.: Delta model no.: HEH080AB 1-4. Thermal and Airflow Airflow circulation is shown in below diagram. An internal temperature sensor has been placed in the return air for safe operation. Cool air flows into the heater, and warmed up by PTC heating element inside of case, then supplied to the system.
Part no.: Delta model no.: HEH080AB 2 Electrical Specification 2-1. Indicator & Connector Power Supply Connector Power input: AC power input with blade terminal. (1) AC Power Connect : Heater starts to heating point (2) Electrical connection : Power input: Terminal block 2P with AC L & N input.
Part no.: Delta model no.: HEH080AB 2-2 Protection Over Temperature Protection: Fuse: Cut-out temperature: 167°C 3. Environmental Condition Operating Temperature -30 °C ~ +40 °C (-22 °F ~ +104 °F) Storage Temperature -40 °C ~ +75 °C (-40 °F ~ 167 °F) ...
Part no.: Delta model no.: HEH080AB 6. Fault analysis and processing Fault State Analysis of the Reasons Solutions • Check the power supply and • Power failure or no the electric circuit. • Check the ambient power. • The target temperature...
Part no.: Delta model no.: HEH080AB 7. Reclaim At the end of the unit working life, the produce must not be disposed of as urban waste. It must be taken to a special local authority differentiated waste collection center or to a dealer providing this service.