Table of Contents
Advertisement
Available languages
Available languages
AMPLIFIER ACTIVATES THE PROTECTIVE CIRCUIT / THE PROTECT LED LIGHTS UP
Check the following steps:
Short circuit on the speaker cables
• First disconnect all speaker cables from the amplifier. Use a multimeter to check the ohmic impedance
of each loudspeaker by measuring between its plus and minus lines. With standard loudspeakers the
value fluctuates between 3 and 5 ohms. The values for low-resistance subwoofers can be lower.
• The measurement shows a resistance value of less than 0.5 Ohms
Then there is a short circuit. Remove the wiring of the affected loudspeaker at its connections. Now
use the multimeter to check the ohmic impedance directly at the loudspeaker connections by measur-
ing between the plus and minus connections.
The measurement shows a resistance value of more than 0.5 Ohms
• The speaker is fine, so the speaker wire appears to be defective and causing a short circuit.
Replace the defective speaker cable.
The measurement shows a resistance value of less than 0.5 Ohms
• The speaker appears to be defective and is shorting out. Replace the defective speaker.
The load impedance of the loudspeakers or the subwoofer is too low
• Compare the ohmic impedance of the connected loudspeaker or subwoofer with the technical speci-
fications of the amplifier. For example, if the amplifier is only designed for 2 or 4 ohm operation, no
loudspeaker with less than 2 ohms may be connected.
The cross-section of the power cables is too small
• If the cable cross-section is too small, this leads to an increased ohmic resistance and thus to a volt-
age drop (voltage loss). This indicates that the amplifier consumes more power. The increased power
consumption results in a significantly higher heat development and the amplifier switches to thermal
protection mode. Therefore, observe the recommended cable cross-sections in these instructions and, if
necessary, lay power cables with a larger cable cross-section.
The amplifier is overheated
• The heat sink of each amplifier requires sufficient air circulation to be able to dissipate the heat gener-
ated during operation. If necessary, change the installation position in favor of better cooling of the
amplifier or ensure better air circulation at the installation location.
• Turn off the sound system and wait about half an hour for the amplifier to cool down again. With very
hot outside temperatures and strong sunlight, enormous heat develops inside the vehicle. The amplifier
then activates its thermal protection circuit to prevent damage. After cooling down, the amplifier works
properly again.
CAUTION
All instructions in this trouble shooting refer to the entire sound system and its individual compo-
nents. The features of your device may not match the functions described in the notes. Then skip
this point and move on to the next one.
ENGLISH
25
Advertisement
Table of Contents
