Table of Contents
Advertisement
MAIN CV DRIVELINE SHIELD SERVICE INSTRUCTIONS
1.
Clean and grease bushing groove before the bushing is placed in the groove. Grease any remaining
bushings in guard.
2.
Slide guard half over driveline and insert bushing tabs into the openings in the guard.
3.
Turn the bushing until it engages into the guard.
4.
Push Easy Lock clip into position. The bushing and guard are now secure.
5.
TO REMOVE GUARD - Use screwdriver to release Easy Lock clip. Turn the bushing to disengage
from the guard and remove guard. Figure Mnt-R-0359
MPORTANT! Check that Guard Missing decal on steel tube under inner
guard and Rotating Driveline Decal are firmly affixed, undamaged and
readable. If not, replace.
FN180/FN120 01/11
©2011 Alamo Group
MAINTENANCE
Maintenance Section 5-7
Advertisement
Chapters
Table of Contents
