Advertisement
Mounting Method
① Mark hole positions in such a way that the product
is placed horizontally.
② Make prepared holes and x the product using 4
supplied wall-mounting screws (pan head tapping
screw).
CAUTION
■ Use the supplied wall-mounting screws for
installation.
Failure to do so could cause the installed
product to be unstable and drop, and may
result in injury.
■ Make sure that the product has no backlash
after the installation is complete.
If the product has backlash, it could come off
or the wall could collapse, which could result in
user's fall and injury.
How to Use
■How to set paper rolls
① While lifting the paper cutting plate,
② insert paper rolls from the side.
①
②
Cleaning
Normal cleaning
● After wetting a cloth with water or lukewarm water, wring it out thoroughly and then use it to wipe the product.
Cleaning when the product is very dirty
● Wipe with a cloth dampened with appropriately-diluted neutral detergent, and then wipe with
a cloth dampened with water. After that, wipe off moisture clean with a dry cloth.
Precautions for cleaning
Do not use the following things that can damage the surface of the product.
● Acid cleaner, alkaline cleaner, and chlorine bleach
● Solvents such as thinner and benzine
● Cleaners containing rough particles such as cleanser and polishing powder
● Nylon scrubbing brush, other brushes, etc.
Wall-mounting screw positions
90 to 110
25
Double paper holder
with shelf
YH700AD
Double paper holder
YH700AW
■How to cut paper
<One-hand cutting function>
① Pull out the paper diagonally
downward.
② Place the blade of the paper
cutting plate on the edge of the paper and
cut the paper along the paper cutting plate
at an angle of about 45°.
*Depending on paper quality and the way of cutting, paper may dif cult
to cut off.
3
90 to 110
Wall-mounting screw
(pan head tapping screw φ4.5 x 40): 4 pieces
Wall-mounting screw
(pan head tapping screw φ4.5 x 30): 4 pieces
①
Alkaline
Thinner
acid
cleaner
②
Cleanser
Advertisement
