Displays2go RWDRYERS5 Assembly Instructions

ASSEMBLY INSTRUCTIONS
RWDRYERS5 - Roll and Write 5 Tier Book Display with Dry Erase Board

How to join 2 boards with CAM lock:

(a) Insert cam post into flat surface of a board and fix it with
a screw driver. Do not over tighten. Fit the hole in the edge
of the joining board over the cam post.
(b) Insert the cam lock into the cam hole. Be sure the
opening section on the back fits the head of the cam post.
(c) Use a screw driver to turn the cam lock clockwise so it
locks onto the head of the cam post. Do not over tighten.
WORK ON A CLEAN SMOOTH SURFACE
1. Identify Vertical Panels (E and F), and Shelves (G and H) as marked in the image below. Insert 3 cam posts (H2) into
holes on the Vertical Panel E. Tighten only until snug. Do the same for all Panel F and Shelf G.
Attach 1 Shelf G to Panel E by inserting cam posts into corresponding holes as shown. Insert 3 cam locks into the cam lock
holes on Shelf G, use a phillips screw driver to turn cam locks clockwise to secure cam posts.
Attach 1 Panel F to Shelf G and fix it with cam locks. Assemble the remaining Panel F, G and Panel H in sequence as shown
in the image below.
DO NOT over-tighten.
2 people
are required
Tool Needed:
Phillips Screwdriver
G
H
F
No. Qty. Description
A 1 Top Panel
B1 1 Side Panel-Left
B2 1 Side Panel-Right
1 Bottom Panel
C
D 1 Back Panel
1 Vertical Panel - Front
E
3 Vertical Panel - Middle
F
Shelf
3
G
1 Shelf
H
1 Front Panel
I
(a)
H2
Join Panels
G
F
F

PARTS LIST

No. Qty. Description
H1
56 Cam Lock
H2
56 Cam Post
H3 2 Caster with Brake
H4 2 Caster
H5 16 Wood Screw and Washer
10
H6 Wood Screw
(b) (c)
H1
Tighten Cam Lock
Insert Cam Lock
G
E
V21.06
1 of 3