Stihl MS 192 T Manual page 49

9.6.2 Removing and installing
– Remove fan housing,
b 10.2
– Remove the handle moulding
and actuating levers, b 12.1
– Remove the switch shaft, b 12.3
1
: Remove the cover (1).
1
: Take out the screw (arrow) and
remove the ground wire (2).
: Disconnect the short circuit
line (1).
48
: Remove the cable guide (arrow).
: Remove the cable guides
(arrows).
2
: Remove the contact springs
(arrows) from the handle
housing.
1 2
: Examine the wiring harness (1),
contact spring (2), contact spring
(3) and grommets (arrows) and
replace if necessary.
For safety reasons, contact spring
(3) may only be replaced together
with the wiring harness.
1
– Plug the contact spring (1) into
the terminal socket of the wiring
harness.
: Place the contact springs in the
guides (arrows).
3
MS 192 T