Installation - Frigidaire FRG912SC Use & Care Manual

Table of Contents

Advertisement

Problem
Steam and condensation settle on
the food and in the cavity of the
oven.
The flame extinguishes immediately
after ignition.
Service data
If you cannot find a solution to the problem yourself,
contact your dealer or an Authorised Service Centre.
Model (MOD.)
Product number (PNC)
Serial number (S.N.)

Installation

WARNING!
Refer to Safety chapters.
Gas connection
.
WARNING
Before the gas connection, disconnect the mains
plug from the mains socket or deactivate the
fuse in the fuse box. Close the primary valve of
the gas supply.
The gas supply ramp is on the rear side of the
appliance.
WARNING
Do not use rubber flexible pipes!
Do not fully put the oven into the built-in cabinet
(approximately 30 cm).
Connection with a flexible metallic pipe or a
rigid metallic pipe:
18
Possible cause
You left the dish in the oven for too
long.
Thermocouple is not heated up
sufficiently.
We recommend that you write the data here:
Do not leave the dishes in the oven
for longer than 15 - 20 minutes
after the cooking process ends.
After lightning the flame, keep the
knob for the gas control pushed for
15 seconds or less.
The necessary data for the service centre is on the
rating plate. The rating plate is on the front frame of the
appliance cavity. Do not remove the rating plate from
the appliance cavity.
.........................................
.........................................
.........................................
1
2
3
4
5
6
7
1. Inlet pipe
2. Nut
3. Seal
Remedy

Advertisement

Table of Contents
loading

Table of Contents