Husqvarna 525LK Operator's Manual page 13

• Do an overall inspection of the product.
• Do the safety inspections, maintenance and
servicing that are given in this manual.
• Make sure that all covers, trimmer guard and
trimmer head correctly attached and not damaged
or cracked. Replace if they are exposed to impact or
cracked.
WARNING:
without a guard or a guard that is defective.
To prepare the product for start
1. Press the air purge again and again until the fuel
starts to fill the bulb.
Note:
It is not necessary to fully fill the bulb.
2. Move the choke control up into choke position.
1027 - 003 - 09.06.2022
Do not use the product
WARNING:
will start to rotate immediately when you
start the engine with the choke.
To prepare a cold engine for start
1. Push the air purge bulb again and again until fuel
starts to fill the bulb. It is not necessary to fill the air
purge bulb fully.
2. Move the choke control up into choke position.
WARNING:
starts to rotate immediately when you
start the engine with the choke.
To prepare a warm engine for start
1. Push the air purge bulb again and again until fuel
starts to fill the bulb. It is not necessary to fill the air
purge bulb fully.
2. Pull the starter rope handle until the engine starts.
Push the throttle trigger slowly to increase the speed
gradually.
The cutting attachment
The cutting attachment
13