Advertisement
Quick Links
Advertisement
Related Manuals for IMPACT ACOUSTIC Chatpod 300
Summary of Contents for IMPACT ACOUSTIC Chatpod 300
- Page 1 30min Assembly instructions Chatpod 300...
- Page 2 Insert the supply cable and the 2m cable into the H-distributor until they click into place. click supply cable 5m cable 2m Chatpod 300 Impact Acoustic AG, Bodenhof 4, 6014 Luzern (Switzerland)
- Page 3 This should go easily, if not, make sure the sides and bottom are aligned. Hold the sides until the top is assembled. Pin the top together with the sides, pull the cable through the top from the right side. click Chatpod 300 Impact Acoustic AG, Bodenhof 4, 6014 Luzern (Switzerland)
- Page 4 3 Insert the eight connecting rods. Chatpod 300 Impact Acoustic AG, Bodenhof 4, 6014 Luzern (Switzerland)
- Page 5 4 Insert the wooden dowels into the holes. Join the two back panel elements and pull them together with the connectors. Do the same with the front elements. Chatpod 300 Impact Acoustic AG, Bodenhof 4, 6014 Luzern (Switzerland)
- Page 6 Do the same with the front. Now tighten all the screws, which must be countered on the opposite side. M6 x 40mm Chatpod 300 Impact Acoustic AG, Bodenhof 4, 6014 Luzern (Switzerland)
- Page 7 Screw the two steel plates to the table column. The screws must be tightened with 30Nm. The handle of the table column must not be operated until the table is completely assembled! M8 x 16mm M8 x 45mm Chatpod 300 Impact Acoustic AG, Bodenhof 4, 6014 Luzern (Switzerland)
- Page 8 Screw the mounting plate to the side with the two 6.3x70mm screws. Screw the table column to the base with the eight 7x30mm screws. Fix the table column additionally with the sheet metal piece and the two M6x12mm screws. Euro screw 6x20mm 7x30mm M6x12mm 6.3x70mm Chatpod 300 Impact Acoustic AG, Bodenhof 4, 6014 Luzern (Switzerland)
- Page 9 Example mounting (depending on monitor bracket) Exemple de montage (selon le support du moniteur) Beispielmontage (abhängig von Monitorhalterung) Example mounting (depending on monitor bracket) Exemple de montage (selon le support du moniteur) Chatpod 300 Impact Acoustic AG, Bodenhof 4, 6014 Luzern (Switzerland)
- Page 10 Remove the four honeycomb cardboard blocks. Align the chatpod using the four leveling feets. Insert the plug as shown. Place the two outer panels on the cover. Plug the power cord into the socket. click Chatpod 300 Impact Acoustic AG, Bodenhof 4, 6014 Luzern (Switzerland)
- Page 11 3 mm hex key. Make sure that the handle is mounted with the pre-mounted square pin in the inside of the chatpod. Well done! Chatpod 300 Impact Acoustic AG, Bodenhof 4, 6014 Luzern (Switzerland)