Table of Contents
Advertisement
CONNECTING SEVERAL UNITS
Interconnecting smoke detectors
To connect several smoke detectors, press and hold the base button on all individual units
until the red lights flash three times. The red indicator lights will continue to flash for one
minute while waiting for other devices to pair. If you need to end the pairing in advance,
press the button again.
Press and hold the base button for the second alarm device. After the red light flashes
twice, release the button. At this time, the red light will flash slowly. If the pairing is
successful, the light will flash three times.
If the products have been paired with other groups before, it will exit directly after the red
light flashes quickly four times. For a successful match, you should clear paired data first.
Note: The equipment has been matched before delivery.
Clearing paired data: press and hold the base button and wait for the red light to blink for
four times, release the button. If the paired data is cleared successfully, it will flashes three
times slowly and exit. Otherwise, repeat the above steps to clear.
FUNCTIONS
Low voltage alarm:
When the built-in battery voltage of the smoke detector is below 27V, the red indicator light
flashes once every 50 seconds, accompanied by a beep sound. The app will also show a
warning in the status bar.
Smoke alarm fault:
The LED of the smoke alarm flashes once every 8 seconds and is accompanied by a buzzer.
The app status will display an alarm fault.
If the device operates normal the red LED indicator flashes once every 55 seconds.
16
Advertisement
Table of Contents
