Weber Spirit PREMIUM E-310 Owner's Manual page 22

BURNER TUBE CLEANING
OR REPLACEMENT (continued)
Clean Burner Tubes
You will need: A torch, a wire (a straightened-out coat
hanger), a suitable stainless steel bristle brush, and a soft
bristle brush (toothbrush) .
A) Look inside each burner tube and Crossover tube with
a torch (1) .
B) Clean any debris or blockage from the inside of the
tubes with the wire (2) .
C) Check spider/insect screens at the ends of the burner
tubes and clean them using the soft bristle brush (3) .
m CAUTION: Do not clean the spider/insect
screens with hard or sharp tools. Do not
dislodge the spider/insect screens or
enlarge the screen openings.
D) Use the steel bristle brush to clean the outside of the
burner tubes and the Crossover burner tube . This is
done to make sure all burner ports (openings) running
along the length of the tubes are fully open . When
cleaning burner tube 1, avoid damaging the ignitor
electrode by carefully brushing around it (4) .
m CAUTION: Do not enlarge the burner
ports when cleaning.
22
WWW.WEBER.COM
ANNUAL MAINTENANCE
1
2
3
4