Operation; First Use; Daily Use - IKEA TILLREDA Manual

Hide thumbs Also See for TILLREDA:
Table of Contents

Advertisement

Available languages

Available languages

ENGLISH

Operation

Switching on
Insert the plug into the wall socket. Turn the
temperature regulator clockwise to a medium
setting.
When operating the refrigerator for the first
time, run it without loading any food until it
autos tops at the desired temperature. Usually
it takes 2 or 3hours, then set the thermostatic
dial at the setting desired and put foods in the
refrigerator.
Switching off
To turn off the appliance, turn the temperature
regulator to the "OFF" position.

First Use

Cleaning the interior
Before using the appliance for the first time,
wash the interior and all internal accessories
with lukewarm water and same neutral soap so

Daily Use

Accessories
Defrosting tray
Temperature regulation
The temperature is automatically regulated.
To operate the appliance, proceed as follows:
turn the temperature regulator toward
lower settings to obtain the minimum
coldness.
turn the temperature regulator toward
higher settings to obtain the maximum
coldness.
A medium setting is generally the most
suitable.
However, the exact setting should be chosen
keeping in mind that the temperature inside the
appliance depends on:
room temperature
how often the door is opened
the quantity of food stored
the location of the appliance.
Important! If the ambient temperature is
high or the appliance is fully loaded, and the
appliance is set to the lowest temperatures,
it may run continuously causing frost to form
on the rear wall. In this case the dial must be
set to a higher temperature to allow automatic
defrosting and therefore reduced energy
consumption.
as to remove the typical smell of a brand-new
product, then dry thoroughly.
Important! Do not use detergents or abrasive
powders, as these will damage the finish.
Defrost the freezing compartment whenever the
layer of frost on the surface of the evaporator
reaches 3 or 4 mm. When defrosting remove all
food and set the thermostat at "OFF" position.
Put the drip tray under the evaporator to
collect melted water. After the frost has melted,
discard the melted water and dry up the interior
of refrigerator. The refrigerator can then be
restarted by turning its thermostat to the
desired setting.
11

Advertisement

Table of Contents
loading

This manual is also suitable for:

Lagan

Table of Contents