Toro Workman GTX Series Installation Instructions Manual page 2

Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description
No parts required
Side upright frame bracket
Front upright frame bracket
Pipe bracket
Front support bracket (with 2 holes on each
side)
Cross-support bracket
Fire-extinguisher mount
Fire-extinguisher support
Shovel mount
Front support bracket (with 1 hole on each
side)
Hex-head screw (1/4 x 3/4 inch)
Carriage bolt (5/16 x 3/4 inch)
Flange nut (5/16 inch)
Cup-cutter bracket
Preparing the Machine
Park the machine on a level surface, set the parking brake,
shut off the engine, and remove the key.
Installing the Bed Rack Kit
If you want to install the Bed Rack Kit on both sides of the
cargo bed, you will need the following additional parts:
•
1 side upright frame bracket
•
1 pipe bracket
•
1 cross-support bracket
•
1 fire-extinguisher mount
•
1 fire-extinguisher support
•
3 shovel mounts
•
4 hex-head screws (1/4 x 3/4 inch)
•
26 carriage bolts (5/16 x 3/4 inch)
•
26 flange nuts (5/16 inch)
•
1 cup-cutter bracket
Note: The Bed Rack Kit can be installed on either side of
the cargo bed.
Qty.
–
Prepare the machine.
2
2
1
1
1
1
1 Install the bed rack kit.
3
1
8
34
34
1
1. Loosely install the 2 side upright frame brackets to the
outside of the cargo bed with 4 hex-head screws (1/4 x
3/4 inch) as shown in
1. Side upright frame bracket 2. Hex-head screw (1/4 x 3/4
2
Use
Figure 1.
Figure 1
inch)