Advertisement
Programming Flow Pumps
Note: Follow LOOP controller instructions to
ensure DC Flow pumps are properly connected
and manifold connection Hubs are compatible.
DC Pump
DC Pump
#2
#1
Use toggle to turn all flow pumps On / Off.
Temperature & Settings Reset
Temperature is currently set up as a visual
indication only. When temperature is within
your safe settings, it will be displayed in
Green
on the Home screen. When out of
range, it will be displayed in Red.
To setup Temperature:
1
Tap Settings icon.
2
Tap Temperature.
Wave
To reset app settings to factory default:
1
Tap Settings icon.
2
Tap Settings Reset
3
Tap OK to erase all previous settings
and return to app factory defaults.
4
Go to lighting and pump programs,
factory resets will take effect.
To program Flow Pump 1 or 2:
LOOP Controller
1
Tap Flow Pump 1 or Flow Pump 2.
2
Use toggle to turn pump On / Off.
3
Use slider to adjust Flow Rate.
4
Use toggle to turn Night Mode On / Off.
5
Tap
to go back, or
select another pump at bottom.
3
Use toggle to select degrees F or C.
Tap Minimum Temperature (down arrow)
4
and select the lowest temperature your
aquarium water should safely reach.
Tap Maximum Temperature (down arrow)
5
and select the highest temperature your
aquarium water should safely reach.
Tap
to go back, or
6
select another pump at bottom.
QUICK START
Additional Info:
Indicates what version App
your device is running
Link to Current USA
Privacy Policy
Link to Current USA
Terms of Service
Help Center Link
Advertisement
