Download Print this page
Garmin LIVESCOPE Installation Instructions Manual

Garmin LIVESCOPE Installation Instructions Manual

Advertisement

Quick Links

Important Safety Information
See the Important Safety and Product Information guide in the chartplotter or fishfinder product box for product
warnings and other important information.
To obtain best performance and to avoid possible damage, you must install this mount using these instructions.
Read all installation instructions before proceeding with the installation. If you experience difficulty during the
installation, go to
support.garmin.com
Battery Information
Battery Warnings
Failure to heed the following warnings could result in death, serious injury, or property damage.
A lithium-ion battery is used for this device.
If these guidelines are not followed, batteries may experience a shortened life span or may present a risk of
damage to the device, fire, chemical burn, electrolyte leak, and/or injury.
• Use only the external battery charger provided by Garmin
• Only use the battery with Garmin approved products.
• KEEP BATTERIES AWAY FROM CHILDREN.
• Do not directly or indirectly short any wiring, terminals, or contacts of the battery.
• Do not disassemble, modify, remanufacture, puncture or damage the battery.
• Do not expose the battery to fire, explosion, or other hazard.
• Do not use a sharp object to remove or tamper with the battery or parts of the battery.
• Do not immerse or expose the battery to water or other liquids. Do not allow the battery to get wet.
• Do not store the battery in your vehicle or in high temperature areas. Do not leave the battery exposed to
a heat source or in a high-temperature location, such as in the sun in an unattended vessel. To prevent the
possibility of damage, remove the battery from the vessel or store it out of direct sunlight.
• Do not attempt to charge the battery outside of the following range: from 10° to 45°C (from 50° to 113°F).
• Do not operate (discharge) the battery outside of the following temperature range: from -20° to 60°C (from -4°
to 140°F).
• When storing the battery for an extended time period, store within the following temperature range: from 20°
to 40°C (from 68° to 104°F).
• Do not connect any cables to the battery that are not approved for this battery by Garmin.
• Only replace the battery with the correct replacement battery. Using other batteries presents a risk of fire or
explosion. To purchase a replacement battery, see your Garmin dealer or buy.garmin.com.
• Do not leave the battery unattended while charging.
• Do not leave the battery charging near wood, carpet, paper, or other flammable materials.
• Check the battery connections for correct polarity before charging.
• Recharge the battery promptly after it is discharged, ideally within 24 hours. Charge battery every six months
during long term storage to maintain peak performance.
April 2022
LIVESCOPE
ICE FISHING BUNDLE LI
INSTALLATION INSTRUCTIONS
for more information.
WARNING
WARNING
.
®
GUID-9BAD0F2E-3BD5-4E05-94E2-A73EB306A36C v3

Advertisement

loading
Need help?

Need help?

Do you have a question about the LIVESCOPE and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Garmin LIVESCOPE

  • Page 1 40°C (from 68° to 104°F). • Do not connect any cables to the battery that are not approved for this battery by Garmin. • Only replace the battery with the correct replacement battery. Using other batteries presents a risk of fire or explosion.
  • Page 2 Charging the Battery WARNING Do not connect any cables to the battery that are not approved for this battery by Garmin. Only use the included all-in-one cable and charger to charge the battery. Ensure that you connect the correct connector to the correct battery terminal. Damage to the battery or device, or bodily harm may occur if the device is improperly connected to the battery.
  • Page 3 3 Place the base between the handle and the top pole , and screw them together. 4 Determine how many of the three middle pole segments you need to use, based on the thickness of the ice. TIP: The top of the transducer must be below the bottom of the ice for best performance. 5 Screw together the needed segments, with the shortest segment on the bottom of the pole.
  • Page 4 9 Position the transducer for the desired view. TIP: Turn the transducer one click to change the orientation from forward to down 10 Place the mount base around the hole in the ice. 11 Rotate the handle to aim the transducer. Effective Forward and Down Range NOTE: Water conditions and bottom conditions affect the depth and range performance of the transducer.
  • Page 5: Battery Specifications

    178 mm (7 in.) Data output Garmin Marine Network The actual battery life of a fully charged battery can vary based on the device used, backlight brightness, temperature the battery is operated and stored in, age of the battery, and depth of the water.
  • Page 6: Open Source Software License

    /linux/. © 2021 Garmin Ltd. or its subsidiaries Garmin ® and the Garmin logo are trademarks of Garmin Ltd. or its subsidiaries, registered in the USA and other countries. LiveScope ™ and Panoptix ™ are trademarks of Garmin Ltd. or its subsidiaries. These trademarks may not be used without the express permission of Garmin.