Section 2 Specifications
2-3-2 Analog output unit (Type: NA0AY02-MR)
(1) Names
The jumper pins in the analog output unit are used to change the analog signal range and digital value range. Therefore, remove
the upper cover and control board when setting the jumper pin.
2) Terminal block
Expansion connector (IN)
1) Status indication LED
2) Terminal block
5) JPA (CH0)
5) JPA (CH1)
NA0AY02-MR
Pin layout of control board
(When the upper cover is removed)
Expansion connector (OUT)
Nameplate
4) JPB (CH0)
4) JPB (CH1)
3) JP1
2-14