Table of Contents
Advertisement
C
S
O
'
M
OMMAND
EEDER
PERATOR
S
ANUAL
Whenever the hopper is used for fertilizer spreading it is extremely important to
carefully clean out the hopper and wash the machine with hot water. Do not
forget that fertilizer is highly corrosive and should be not left in the hopper any
longer than necessary.
Hourly or whenever an obstacle is hit:
1. Check machine condition.
2. Remove any wrapping (stalks, weeds, trash, etc.) from cultipackers, especially from
around bearing supports on the cultipacker ends.
Every 8 hours:
Grease the cultipacker supports (see fig. 10). Apply two or three shots of grease to
the cultipacker bearings on both front and rear cultipackers.
Every 25 hours:
5
Check hardware tightness; vibration can loosen bolts
. Check tightness of the
hardware periodically.
Every 50 hours:
Inspect all the drive chains from the access panels and make sure they are well
lubricated (see fig. 10).
5
See Table 4, page 22.
M
25
ABI A
AINTENANCE
TTACHMENTS
Advertisement
Table of Contents
