Table of Contents
Advertisement
C
S
OMMAND
EEDER
After the first 200-300 feet it is important to stop and raise the machine. Lower the
machine, turn off the tractor engine and remove the key.
At this point make sure the Command Seeder is performing correctly. Check for loose
bolts or nuts.
Ground speed is determined by the soil condition and tractor power. Simple
experimentation will soon determine the best speed for the desired results, usually 3 to
5 mph.
When the headland is reached, it is important that the following be observed:
1. Raise the machine from the ground.
2. Turn the tractor facing the new desired direction of travel.
3. Begin working again.
NOTE: Best practice dictates that the machine be lifted no more than just enough
to clear the ground.
DANGER: Be careful when operating tractor and machine over uneven ground to
avoid rollover.
The following precautions should always be observed when working on uneven terrain:
1. In extremely uneven terrain rear wheel weights, front tractor weights, and/or tire
ballast should be used to improve stability.
2. Observe the type of terrain and develop a safe working pattern.
3. Operate the implement up and down steep slopes, not across slopes, to prevent the
tractor from tipping. Avoid sudden stops and starts, and slow down before changing
directions on a slope.
4. Pass diagonally through sharp dips and avoid sharp drops to prevent hanging up the
tractor and implement.
5. Slow down on sharp turns and slopes to prevent tipping or loss of control.
6. Watch for holes, roots or other hidden objects. Do not use near the edge of a gully,
ditch or stream bank.
O
PERATION
3.09 - Test Run
3.10 - Working Speed
3.11 - Headland Procedure
3.12 - Uneven Terrain
20
O
'
M
PERATOR
S
ANUAL
ABI A
TTACHMENTS
Advertisement
Table of Contents
