Maintenance And Servicing; Troubleshooting - Central Pneumatic 97014 Set Up And Operating Instructions Manual

Engine cleaning gun with siphon hose

Hide thumbs

Table Of Contents

Table of Contents

You can adjust the amount of engine cleaning solution being used by turning the

Siphon Control Knob (6) counterclockwise for more solution and clockwise for

less. See Figure 1 on page 6.

Hold the end of the Spray Nozzle (4) approximately 6 to 10 inches from the

engine and squeeze the Knurled Knob Trigger (5).

10.

It is best to keep the Gun in motion with a back and forth action.

11.

When the job is completed, flush the Siphon Hose (2) by placing it into a

container filled with clean, clear water and spraying it in a safe direction until

only clean water comes from the Spray Nozzle (4).

12.

To prevent accidents, disconnect the air supply after use and store the tool

indoors out of children's reach.

warning

BeFore each use, inspect the general condition of the tool. Check for

loose hose connections, cracked hoses, inoperative trigger and siphon control,

cracked or broken parts, and any other condition that may affect its safe

operation.

aFter use, clean external surfaces of the tool with clean, moist cloth.

problem

Tool has low air

output

SKU 97014