User Tips - Whirlpool DM201NA Health & Safety, Use & Care And Installation Manual

User Tips

To Empty the Water Tank
(1) When the water tank is full, "Full" blinks. The machine stops.
(2) Do not remove the water tank immediately as the machine is still working or just stopping.
This might cause some water dripping inside the machine.
(3) To remove the water tank, first pull it out, then lift carefully.
(4) After pouring out the water, clean the water tank and restore it in place.
Remark:
- After restoring the water tank, if the "Full" indicator still blinks, this indicates that the water
tank is not in proper position. Please remove the water tank and restore it again.
- To avoid residual water from leaking into the machine, please do not remove the water tank
once the Dehumidifying / Laundry is completed.
To pull out
To Drain Water
You may use a hose with an inner diameter of
12mm for continuous drainage:
(1) Use a screwdriver to remove the knockout at the back.
Attach the tubing to the connector through the hole.
(2) The tubing should be lead to the drain with no sharp bends.
To Set the Unit
Do not insert small
objects into the cabinet or
damage may result.
To Move the Unit
(1) Retractable Handle is provided to allow you to move the unit easily from one place to another.
(2) Unplug the power cord and empty the water tank before moving the unit.
(3) Before operating the unit, make sure the water tank is well in place.
To lift
Keep a clearance of at least 5 cm
at the back for air intake.
Put the machine in a stable horizontal
surface or water may leak.
7
To restore
back