Pioneer VSX-917V Operating Instructions Manual page 24

04 Controls and displays
DIGITAL – Lights when a digital audio
signal is detected.
2 DIGITAL – Lights when a Dolby Digital
encoded signal is detected.
ANALOG – Lights when an analog signal is
detected.
DTS – Lights when a source with DTS
encoded audio signals is detected.
2
Lights to indicate decoding of a DTS
multichannel signal.
2 DIGITAL
3
Lights to indicate decoding of a Dolby Digital
multichannel signal.
2 PRO LOGIC IIx
4
2 PRO LOGIC II lights to indicate Pro Logic II
decoding. 2 PRO LOGIC IIx lights to indicate
Pro Logic IIx decoding (see Listening in
surround sound on page 28).
5 VIR.SB
Lights during Virtual surround back
processing (page 32).
6 DIRECT
Lights when source Stream Direct playback is
in use. Direct playback bypasses the tone
controls for the most accurate reproduction of
a source.
7 AUTO SURR.
Lights when Auto Surround (see Auto playback
on page 28) or XM HD Surround (page 54) is
on.
8 ATT
Lights when ANALOG ATT is used to
attenuate (reduce) the level of the analog input
signal.
9 SLEEP
Lights when the sleep mode is active (see
Remote control below).
24
En
10 Tuner indicators
– Lights when the mono mode is set
using the MPX button.
– Lights when a stereo FM broadcast is
being received in auto stereo mode.
– Lights when a broadcast is being
received.
11 Speaker indicators
Lights to indicate the current speaker system,
A and/or B (page 59).
12 Character display
13 Neo:6
Lights to indicate Neo:6 processing.
14 ADV.SURR. (Advanced Surround)
Lights when one of the Advanced Surround
modes has been selected.
15 WMA9 Pro
Lights to indicate decoding of a WMA9 Pro
signal.
16 MIDNIGHT
Lights during Midnight listening (page 32).
17 D.E.
Lights when Dialog Enhancement is switched
on (page 33).
18 LOUDNESS
Lights during Loudness listening (page 32).
19 EX
Lights when a Dolby Digital Surround EX
encoded signal is detected.
20 Master volume level
Shows the overall volume level.
21 MCACC channel EQ / Sound Retriever
indicators
These indicators show the EQ balance for each
channel in Checking your Acoustic Calibration
EQ settings on page 40. Also, L and R light
when the Sound Retriever is active (page 33).