Advertisement
Specifications
Range
Measuring Accuracy*
Smallest Unit Displayed
Laser Class
Laser Type
Laser/Backlight Automatic Switch-off
Unit Automatic Switch-off
Continuous Measuring
Area/Volume
Battery Life (2 x AAA)
Dimension (H x D x W)
Weight (without Batteries)
Storage Temperature Range
Operating Temperature Range
*
Measuring Accuracy depends on the current conditions:
•
Under favorable conditions (good target surface and room temperature), up to 33ft (10m).
•
Under unfavorable conditions (bright sunlight, a very weak reflecting target surface, or large temperature
fluctuations), the error can increase by to ± 0.003 in/ft (± 0.25mm/m) for distances over 33ft (10m).
Error Codes
If INFO appears on the display window with a Code number, perform the corresponding Corrective Action.
Code
Description
101
Received Signal Too Weak,
Measuring Time Too Long
102
Received Signal Too High
201
Too Much Background Light
202
Laser Beam Interrupted
203
Insufficient Power
301
Temperature Too High
302
Temperature Too Low
401
Hardware Error
402
Unknown Error
6in to 65ft (15cm to 20m)
± 1/8in (± 3mm)*
± 1/16in (± 1mm)
Class 2 (IEC/EN60825-1: 2014)
≤ 1.0mW @ 620-690nm
After 30s
After 90s
Yes
Yes
Up to 3000 Measurements
4.64 x 1.69 x 1.02in (118 x 43 x 26mm)
2.5oz (71g)
-13° F ~ 158° F (-25° C ~ +70 C)
32° F ~ 104° F (0° C ~ +40° C)
Corrective Action
Use the target plate or change the target surface.
Target is too reflective. Use the target plate or change the
target surface.
Reduce the background light on the target area.
Remove the obstacle and repeat the measurement.
Replace the batteries.
Allow the device to cool down to a temperature within the
specified Operating Temperature Range.
Allow the device to warm up to a temperature within the
specified Operating Temperature Range.
Switch the device on/off several times. If the error still occurs,
return the defective device to the Service Center or distributor.
Refer to the Warranty.
Contact the Service Center or distributor. Refer to the Warranty.
E E
7
Advertisement
