Connecting The Power; Connecting To A Monitor - Advantech MIT-W101 User Manual

3.1

Connecting the Power

Before you can use your MIT-W101, you must fully charge the battery. Connect the
power adapter as shown and leave it to charge for:
 A minimum of 2 hours when using the internal battery
 A minimum of 4 hours when a second battery is installed
Conditions: operating time is based on the LCD backlight at 50% and the average uti-
lization of the system under 10%.
Installation Procedures:
1. Connect the female end of the power adapter to the DC-in of MIT-W101-A.
2. Connect the female end of the power cord to the DC power adapter.
3. Connect the 3-pin male plug of the power cord to an electrical outlet.
Note! Be sure always handle the power cords by holding the plug ends only.
3.2

Connecting to a Monitor

You can connect the MIT-W101 to an external monitor for enhanced viewing.
Connect one end of a HDMI to VGA cable to the Micro HDMI port on the left side of
the MIT-W101.Connect the other end to the VGA cable and connect to the monitor.
MIT-W101 User Manual 12