General Description; Before Creating Fun; Let The Fun Begin - Philips GoZero ADD4901 User Manual

3 General description

Product overview
A1
Refer to
Machine rating of information:
Maximum Working Pressure: 116 psi/ 8 bar
Maximum Allowed Operating Temperature: 40°C / 104°F

4 Before creating fun

Installing the gas cylinder
1. Place the Philips Sparkling water maker in an upright position and on a at surface. Remove the carbonating
bottle before installing or replacing the cylinder if it is filled with water. Remove the drip tray grid and
then carefully lay the Sparkling water maker down on the side.
2. Remove seal and cap from the CO
bottom. Don't drop the cylinder into the hole. When you feel that it reaches the bottom, begin
screwing the cylinder clockwise until it is fastened. Don't screw too hard since this might break the
threads holding the gas cylinder in place.
3. When you need to replace the gas cylinder, lay the Sparkling water maker down on the side and unscrew it
counterclockwise and then carefully pull it out of the compartment.

5 Let the fun begin

1. Fill the carbonating bottle
Rinse the carbonating bottle with cold water before you use it for the first time. Fill the carbonating
bottle with cold, clean water up to the marked filling line.
2. Attach the carbonating bottle
Screw the carbonating bottle into the carbonating bottle socket. Screw counterclockwise if viewed from
above. Don't screw extremely hard - just make sure the carbonating bottle sits properly.
3. Carbonate the water
Press the button downwards firmly until you hear a sound from the valve. The carbonation time is
2-3 seconds for each time.
cylinder. Carefully insert the cylinder through the hole at the
2
A2-1
A3-3
EN 2
A2-2
A3-1
A3-2