R Esetting A Button To Its Original Function; Service And Support; Frequently Asked Questions - Philips SRP 3004/10 User Manual

8
5 . ................................. T V: red fasttext key.
STB: Red, C.
VCR/DVD/STB: s earches fast
2 / GUIDE .............. V CR/DVD: starts playback.
DVD: p ressed together with
selects Electronic Program
Guide.
STB: s elects Electronic Program
Guide. Pressed together with
6 . ................................. T V: blue fasttext key.
STB: B lue, B. Pressed together with
VCR/DVD: searches fast forward.
9 . ................................... V CR/DVD: stops playback / recording.
TV: green fasttext key.
STB: G reen, D. Pressed together with
0 / FAV . ..................... TV: white fasttext key.
V CR/DVD: s tarts recording. Pressed
STB: F avorites. Pressed together with
; . .................................... T V: yellow fasttext key.
VCR/DVD: p ause playback /
STB: Y ellow, A. Pressed together with
3.2 R esetting a button to its original function
If an improved button (see chapter 2.2.2) still does not
function as expected, you can always reset the button to its
original function.
1
I n the current device
mode, keep digit buttons
and pressed
simultaneously for
5 seconds.
• T he remote control is
now in setup mode.
EN
10
backwards.
:
: starts playback.
: searches fast forward.
: stops playback.
together with :
favorites.
: starts recording.
recording.
: pauses playback.
5 sec.
2
P ress digit buttons ,
and , in that order.
• A fter each button press
the device selection
button blinks once.
3
P ress the button you wish
to reset twice. E.g. the 22
button.
• A fter each button press
the device selection
button blinks once.
• T he device selection button will blink one more time
to confirm that the button was succesfully reset to its
original function.
4 Service and support
4.1 Frequently asked questions
In this chapter you will find answers to the most frequently
asked questions about your universal remote control.
4.1.1 Setup
I cannot enter setup mode.
Battery level too low or battery lifetime came to an end.
• R eplace the batteries. For this see chapter 2.1.
After replacing the batteries, test if the remote control
still operates your devices. If it does not, you have to set
up the remote control again. For this refer to chapter 2.2.
The brand code for my device is missing in the 'Shortlist of
brands' in the Quick Start Guide.
The 'Shortlist of brands' only mentions the most common TV,
STB, DVD player / recorder and VCR brands.
• Y ou will find a complete brand list on page 14-29 of this
user manual.
•
U se '9999' as 4-digit code in case you cannot find your brand
in the complete brand list. Note that using '9999' may result
in a long setup (up to 15 minutes).
,
2 x
EN
11