Basic Functions; Plug And Play (For Tuner Installlation); Switching The System On; Power-Saving Automatic Standby - Philips MCM148 User Manual

Basic Functions

STANDBY-ON
MICR O SYSTE M MCM148
iR
MP3-CD/CD - R/CD - RW COMPATIBLE
SOURC E
ALBUM/ PRESET
DBB
IMPORTANT:
Before you operate the system, complete the
preparation procedures.
Plug and Play
(for tuner installlation)
Plug and Play allows you to store all available
radio stations automatically.
First time setup/power up
When you turn on the main supply, "AUTO
1
INSTALL - PLEASE PRESS PLAY / STOP
CANCEL" is displayed.
Press 2; on the system to start installation.
2
"PLUG AND PLAY" .... "INSTALL" is
➜
displayed, followed by "TUNER" and "AUTO".
starts flashing.
➜
prog
The system will automatically store the radio
➜
stations with sufficient signal strength, starting
from FM, and followed by MW band.
When all the available radio stations are
➜
stored or the memory for 40 presets are
used, the first preset radio station will be
played.
To reinstall Plug and Play
In standby mode, press and hold 2; on the
1
system until "AUTO INSTALL - PLEASE
PRESS PLAY / STOP CANCEL" is displayed.
Press 2; again to start installation.
2
All previously stored radio stations will be
➜
replaced.
12
VOL
TUNING
MODE PROG
VOL
To exit without storing the Plug and Play
●
Press 9 on the system.
If you do not complete the Plug and Play
➜
installation, the function will be restarted
when you next turn on the main supply again.
Note:
– During Plug and Play, if no button is pressed
within 15 seconds, the system will exit Plug and
Play mode.

Switching the system on

●
Press STANDBY-ON 2 or SOURCE (PWR,
DISC, TUN, or AUX on the remote control).
The system will switch to the last selected
➜
source.
To switch the system to standby mode
●
Press STANDBY-ON 2 on the system (or
PWR on the remote control).

Power-saving automatic standby

The power-saving feature automatically switches
to standby 15 minutes after a disc playback has
ended and no control is operated.

Adjusting volume and sound

Press VOL + / - to adjust volume.
1
Display shows the volume level VOL and a
➜
number from 0-32.
Press DSC repeatedly to select the desired
2
sound effect: JAZZ / POP / CLASSIC / ROCK.
Press DBB to switch bass enhancement on or
3
off.
Display shows:
➜
Press MUTE on the remote
4
control to interrupt sound
reproduction instantly.
Playback will continue
➜
without sound.
●
To activate sound reproduction you can:
– press MUTE again;
– adjust the volume controls;
– change source.
if the DBB is activated.