Diagnosis - Wow LOOQER Translation Of The Original Instructions

1
Your device is now ready for use!
4.

Diagnosis

When all settings have been made, you can carry out the first diagnosis with the device. To do this, connect the device to
the diagnostic interface of the vehicle.
Attention! During first connection to the LOOQER control unit, it is essential to establish an internet
connection.
When the device is connected to a control unit for the first time, security keys are queried online, a process which allows
a connection to be established between computer, diagnostics device and control unit. For this reason, select a location
where your computer has stable internet access when establishing a connection to a control unit for the first time.
Once this process has been completed in the background, you can use the device to carry out the full range of diagnostic
functions, whereby success depends on the establishment of the connection.
Control unit scan
Open the vehicle selection and select your vehicle. The various ways to do this are described in the -> "WOW! Software
Manual".
Diagnostic functions
In the "WOW! Software Manual", starting with point "4. Diagnostic functions", you will find information on:
4.1 EOBD Diagnosis
4.2 Serial OBD Diagnosis
4.3 Flight recorder
As the fundamental diagnostic functions such as
• reading out and deleting system-related fault memories
• reading out data lists and system information
• actuator test for activating and deactivating individual sensors and actuators
• codings and settings of the systems in the control units
do not differ from those of the previous diagnostic hardware, please refer to the "WOW! Software Manual" for an explana-
tion of the functions.
4. Press Close to save the settings and exit this screen
1
32