How To Use - FEUERHAND BABY SPECIAL 276 User Manual

COMPONENTS
1.
Carrying Handle
2.
Lifting Eyelet
3.
Chimney
4.
Side Piece
5.
Glass with Wire Support
6.
Handle of the Wire Support
7.
Burner with Wick
8.
Rotating Handle
9.
Tank Lid
10.
Tank
DEUTSCH ENGLISCH FRANÇAIS

HOW TO USE

FILL WITH FUEL
Open the tank lid and fill the tank of the
lantern with lamp oil. Fill with fuel just to
the bulge (see marking on figure 1). Before
the first use, the wick needs to soak in fuel.
Therefore, wait for about 20 minutes after
adding adding fuel to the lantern before
lighting it.
LIGHTING THE LANTERN
Lift the glass cylinder of the lantern by pres-
sing the handle on the left side and hooking
it in the notch provided. Light the wick, which
should stick out of the burner by about 1 to
2 mm, with a lighter or a match. As soon as
the wick burns, slowly replace the glass by
means of the respective handle. (Figure 2)
ADJUSTING THE WICK
You can adjust the size of the flame by tur-
ning the rotating handle of the burner. (Figure
3) The flame should not flicker or emit soot.
The recommended size of the flame is bet-
ween 1.5 to 2 cm. The flame becomes extinct
when the wick is turned downwards. Make
sure the flame has really stopped burning by
turning the wick upwards again. Advice: Do
not turn the wick down too far, otherwise it
could lose its grip in the burner.
ESPAÑOL
中文 中文