Settings > U Battery; Settings > Self Test - NSR Marine NGT-200 User Manual

7.8 SETTINGS > U battery
The measured voltage meaning of current power supply source is displayed on
LCD:
= Battery voltage =
3.99 V
Measure - ENTER
Manufact:
7.9 SETTINGS > Self test
This menu item allows doing the self test of NGT-200. Press Enter key to start the
test. The example of the test result is shown as below:
=== Self test ===
RAM :
EEPROM :
Flash :
PLL-LD :
RF TX-RX:
Start - ENTER
Measure - ENTER
Manufact:
- Voltage of internal batteries, if nothing is
connected to USB port;
- Voltage supplied to USB-port, if it's
connected to PC or network USB-adapter.
Tester is automatically switched to USB
power supply source when connected!
Each pressing of Enter key will measure the
voltage again.
02/21
02/21
59
NGT-200 USER MANUAL
=== Self test ===
RAM : OK
EEPROM : OK
FLASH : OX5C7D
PLL-LD : OK
RF TX-RX: OK
Start - ENTER
Measure - ENTER
Manufact: 02/21
NGT-200 UM.E 20210520-02