Download Print this page

AYRSTONE AyrMesh Quick Start Manual

Start Here

Quickstart Guide – AyrMesh

Ayrstone.com/support

Visit

for detailed instructions,

videos, slide shows, and a

troubleshooting guide

Check the contents

of the box:

• AyrMesh Switch

• Power Supply

NOTE: The AyrMesh Switch is designed for use indoors where it will stay warm

(above freezing) and dry. Do not install it in locations where it may become wet,

too hot (over 120 degrees Fahrenheit) or too cold (under 32 degrees Fahrenheit).

Place the end of the power supply into the

Jack on the back of the Switch

Switch

Table of Contents

Need help?

Do you have a question about the AyrMesh and is the answer not in the manual?

Page 1 • AyrMesh Switch • Power Supply NOTE: The AyrMesh Switch is designed for use indoors where it will stay warm (above freezing) and dry. Do not install it in locations where it may become wet, too hot (over 120 degrees Fahrenheit) or too cold (under 32 degrees Fahrenheit).
Page 2 Plug in Power Supply Plug the power supply into the wall. The power light on the front of the switch will come on. Connect Ethernet Cable to Network Connect any Ethernet port on the Switch to your network with an Ethernet cable.