Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Orava EK-2009
Summary of Contents for Orava EK-2009
- Page 1 Electric convector EK-2009 Instruction manual EK-2009...
-
Page 2: General Safety Instructions And Warnings
ORAVA electrical appliances are manufactured according to state-of- the-art knowledge and recognized safety rules. Nevertheless, improper and improper use or improper use may result in injury or endangerment to the life of the user or a third party or to a third party. - Page 3 1.1 General safety instructions • Before operating the unit, we recommend that you carefully read the instruction manual and operate the equipment in accordance with the instructions! • The safety instructions and warnings in this manual do not cover all the possible conditions and situations that may arise when using the device.
- Page 4 4. Occurrence of water: intermittent condensation of water or occurrence of water vapor 5. Occurrence of foreign bodies: quantity and type of dust are insignificant 6. Protection degree: min. IP20 (device protected from touching dangerous parts by hand and non-waterproof) •...
- Page 5 switched off as soon as possible and disconnected from mains supply. • The power cord and mains plug must always be easily accessible for safe disconnection of the electrical appliance from the power supply. • Do not pull off the power cord by pulling the cable. Disconnect the power cord by pulling the plug behind the power cord plug.
- Page 6 1.4 Safety of persons • This appliance is intended for use and operation by persons without electrotechnical qualification - lay people, according to the instructions specified by the manufacturer. • Device operation includes activities such as switching on and off, user manipulation and setting of operating parameters, visual or auditory inspection of the equipment, and user cleaning and maintenance.
- Page 7 1.5 Cleaning, maintenance and repairs • Observe the normal user cleaning and maintenance of the appliance in the recommended way. Do not use solvents or harsh cleaners for cleaning. Pollution and visible stains from finger contact, respectively. The hands can be cleaned using detergent detergents specially designed to clean household appliances.
- Page 8 Special safety instructions. Read carefully! • The electrical device is designed and manufactured in such a way as to enable safe operation and use by persons without professional qualifications. Despite all the precautions that have been taken by the manufacturer for safe use, operation and use carry some residual risks and associated hazards.
- Page 9 Unpacking/Packaging • Unpack and dispose of all parts and accessories of packaging materials, etiquettes and labels before operating the device. Store all packaging materials in a safe place or keep them out of reach of children and vulnerable persons. There is a risk of serious injury! There is a danger of suffocation! Inspection/Commissioning Caution!
- Page 10 Warning! Read carefully. • An electrothermal appliance or an electric heater designed for heating can be installed on the floor of the firefighting class A1fl or A2fl. These technical building materials are classified as non-combustible according to a single European classification system (where index fl means). From the selected materials, we mention e.g.
- Page 11 • The electric heat device or electric infrared heater can only be placed in the bathroom outside the 0-1-2 zone. • The device must be installed in such a way that switches and other controls are not within reach of a person from the bathtub or shower enclosure.
- Page 12 Operation/Supervision Caution! • The device may only be operated if it is in good technical condition and under the conditions laid down in the generally binding regulations on technical conditions and fire safety requirements for installation and these operating and manual instructions.
- Page 13 Caution! • Use extreme caution when operating the device. • At the time of operation, some surfaces of the device become very hot. Do not touch the heated surfaces of the device. Use only handles and grips to handle the device. •...
- Page 14 • Do not use the device near bathtubs, showers, washbasins or other containers containing water, including swimming pool. Do not remove the device if it falls into the water. First, unplug the power cord from the wall socket and then remove it from the water.
- Page 15 • Never leave the device unattended and freely accessible with a free power cord. Children, incompetent persons or animals could pull or tilt the device behind the power cord. • When not in use, unplug the power cord from the wall socket.
-
Page 16: Description Of Parts
Characteristic properties EK-2009 is a modern electric heating convector for heating air in the room, which is equipped with an electronic controller with an LCD display. In addition to simply setting the required power in two stages, the controller allows in manual mode, use the + (plus) and - (minus) buttons to set the desired temperature or operating time. - Page 17 Control panel 1 Indicator (low power level) Low power indicator (900 - 1 000 W) . 2 Indicator (high power level) High power indicator (1800 - 2 000 W) . 3 LED display Display of the set operating time for automatic switch-off of the device after the set time has elapsed and display of the set temperature 4 1 (standby/on/off) button Press to turn the device on / off from / to standby mode.
-
Page 18: Assembly And Operation
Assembly and operation Before first use • Unpack the device and remove all packaging material and any protective film. • Mount the 2 supplied feet on the device using the 4 supplied screws. Screws, 4 pcs Legs, 2 pcs Assembly of legs •... -
Page 19: Settings And Operation
Power supply The device operates on AC voltage 230 V, 50 Hz from the mains. Before using the device, it is necessary to connect the device to the mains using a mains cord to a wall socket with the prescribed voltage. SETTINGS AND OPERATION Place the device in the desired location in the room and set its operation using the controls on the control panel. -
Page 20: Maintenance And Cleaning
Turn off the device • Press the 1 (on/off) button on the control panel to switch the device to standby mode and turn off the power with the main power switch (4) on the side of the device. • Unplug the power cord from the electrical socket. Safety switch •... -
Page 21: Troubleshooting
TROUBLESHOOTING BEFORE CONTACTING SERVICE Before contacting a professional service center, read the following fault overview, which contains common cases that are not a symptom of a fault. Problem Possible cause/solution The device does not work Without power. Plug the device into the outlet properly. Non-standard odor Is the device covered (hot air outlets blocked)? Uncover the device (remove the blockage barrier). -
Page 22: Technical Specifications
Package Contents: convector (1) instructions for use (1) screws (4) legs (2) We reserve the right to make changes! Producer: ORAVA retail 1, a.s. Seberíniho 2 821 03 Bratislava Slovenská republika Importer: ORAVA retail 1, a.s. ORAVA distribution CZ, s.r.o.
Need help?
Do you have a question about the EK-2009 and is the answer not in the manual?
Questions and answers