Panasonic NV-GS80E NV-GS80EB Service Manual page 32

10. Installation of Front P.C.B.
Install the Front P.C.B. with the 5 bosses, and tighten the
5 Screws (537).
537
Front P.C.B.
Boss
537
Boss
537
Boss
Fig. D10
11. Removal of Side R Shaft Case Unit and LCD Case A
Take care not to damage the F.P.C.
1) Open and rotate the LCD to access the 2 Screws (519).
2) Release the 8 Locking Tabs (L-1) and remove the LCD
Case A.
3) Disconnect the F.P.C. from Connector FP8101.
4) Remove the Side R Shaft Unit.
519
Side R Shaft
Unit
LCD
FP8101
Shaft
F.P.C.
LCD Case A
Fig. D11
Boss
537
537
Boss
Rotate to access
519
LCD (Ass'y)
(L-1)
(L-1)
(L-1)
32
12. Installation of LCD Backlight P.C.B., LCD Panel Ass'y,
LCD Shield Case Unit and LCD Case B
Use extreme care regarding LEDs when handling the LCD
Backlight P.C.B.
Install in order shown below.
1) Install the LCD Panel Ass'y onto the LCD Shield Case
Unit with the 3 Locking Tabs (L-4) while carefully
bending the LCD F.P.C. at its base so as not to damage
it.
2) Install the LCD Backlight P.C.B. onto the LCD Panel
Ass'y with the 3 Locking Tabs (L-3).
3) Install the LCD Case B with the 3 Locking Tabs (L-2).
4) Tighten the Screw (533) while keeping the LCD
Backlight P.C.B. pressed toward the left. Then, connect
the F.P.C. to Connector FP8102.
533
LCD Backlight P.C.B.
FP8102
(L-3)
(L-2)
LCD Panel Ass'y
(L-2)
Bend
(L-4)
LCD
Shield
Case
LCD Case B
Fig. D12
(L-3)
Press
(L-3)
LEDs
(L-4)
(L-4)
(L-2)
LCD
F.P.C.