User's Instructions - Rinnai Multi-Point 11i Low NOx Installation And User Manual

Continuous flow water heater
Table of Contents

Advertisement

The following instructions are designed for the user of the water heater. The user may not install or adjust the ap-
pliance in any way that requires the removal of the front cover of the unit. To remove the front cover of the unit you
Information for the Installer is given on page 19.
0800 408 5500 and verify the engineer's name with their database. This is for your own safety.
Responsibilities of the USER
The user must abide by all warnings given in this book. The user must only reference the user section of the book,
and may not carry out any procedure listed in the installer section. This installation manual should be kept with the
appliance for maintenance and user information.
The user must have the unit checked and maintained annually by a gas engineer.
The user must not use the appliance in any way that it was not meant to be used. The user may only use the heater
as detailed in the User portion of this manual.
Interference with a sealed component is not permitted. In case of defect parts only use genuine Rinnai components
for replacement.
practice in the country where the unit is installed.
The user should familiarise themselves with the water heaters gas service valve and the main gas valve to the
premises.
ATTENTION: air surrounding the water heater, venting and vent termination(s) is used for combustion and must
be free of any compounds that cause corrosion of internal components. These include corrosive compounds that
are found in aerosol sprays, detergents, bleaches, cleaning solvents, oil based paints/ varnishes, and refrigerants.
Therefore Rinnai recommends outdoor models be used for these locations where possible.
The water heater, venting and vent termination(s) should not be installed in any areas where the air may contain
these corrosive compounds. If it is necessary for a water heater to be located in areas which may contain corrosive
compounds, Rinnai strongly recommends the following:
Indoor/Internal Water Heaters:
* DO NOT install in areas where contaminated air is present
* Consider before installation where air has the ability to travel within the building
* Where possible, install the water heater in a sealed closet so that it is free of contaminated indoor air
* Chemicals that are corrosive in nature should not be stored or used near the water heater
Outdoor/External Water Heaters and Vent Terminations of Indoor/Internal Water Heaters:
* Install as far away as possible from exhaust vent hoods
* Install as far away as possible from air inlet vents. Corrosive fumes may be released through these vents when air
is not being brought in through them.
* Chemicals that are corrosive in nature should not be stored or used near the water heater or vent termination.
Damage and repair due to corrosive compounds in the air is not covered by warranty.
The exhaust outlet may change colour over time due to the condensate in the exhaust gases. This discoloration
Installers are required to carry out installation, commissioning and servicing work in accordance with the
Benchmark Code of Practice which is available from the Heating and Hot water Industry Council who manage and
promote the Scheme. Visit www.centralheating.co.uk for more information.
Isolate the gas supply and get out of the building. Do not try to light any appliance. Do not turn any light
safe location and follow their instructions. If you cannot reach your gas engineer ring the following:
National Grid 0800 111 999
6
Enfocus Software - Customer Support
USER INSTRUCTIONS
Benchmark places responsibilities on both manufacturers and installers.
The purpose is to ensure that customers are provided with the
correct equipment for their needs, that it is installed, commissioned
and serviced in accordance with the manufacturer's instructions by a
competent person(s) and that it meets the requirements of the appropriate
Building Regulations. The Benchmark Checklist can be used to
demonstrate compliance with Building Regulations and should be provided
to the customer for future reference.
IF YOU SMELL GAS

Advertisement

Table of Contents
loading

Table of Contents