Table of Contents
Advertisement
BATHROOM HEATER USER MANUAL
MODEL: IPH-01
Thank you for choosing Lifeplus Bathroom Heater!
This user manual will provide you with valuable information necessary for the proper care and
maintenance of your new product. Please take a few moments to thoroughly read it and start enjoying
your warm winter!
Always here to help you
Advertisement
Table of Contents
Related Manuals for LIFEPLUS IPH-01
Summary of Contents for LIFEPLUS IPH-01
- Page 1 BATHROOM HEATER USER MANUAL MODEL: IPH-01 Thank you for choosing Lifeplus Bathroom Heater! This user manual will provide you with valuable information necessary for the proper care and maintenance of your new product. Please take a few moments to thoroughly read it and start enjoying...
- Page 2 INTRODUCTION Please take a few minutes to read this manual carefully. Proper maintenance and operation of this machine can provide better service. WARNINGS Read ALL instructions before using this unit. CAUTION: Risk of Electric Shock. DO NOT open or try to repair the heater yourself. ...
-
Page 3: Specification
DO NOT attempt to repair or adjust any electrical or mechanical functions on this unit. Doing so will void your warranty. The inside of the unit contains no user serviceable parts. Qualified personnel should perform all servicing only. Connect to properly grounded outlets only. ... -
Page 4: Product Diagram
PRODUCT DIAGRAM Remote Control Air Intake Control Panel Front Panel Air Outlet Power Switch Front Back... -
Page 5: Control Panel
Control Panel Digital display：Indicate temperature or time. High Mode indicator light: Will be lit when High Heat mode is engaged.. Low Mode indicator light: Will be lit when Low Heat mode is engaged. Energy-saving mode indicator: Will be lit when energy-saving mode is engaged. ℃/℉Button : Alternates between Fahrenheit and Celsius. -
Page 6: Remote Control
Remote Control Temp up button: to increase temperature ON/OFF button: Power on/ off Temp down button: to lower temperature Mode button：to select modes ℃/℉ button: Button for alternating between Fahrenheit and Celsius Timer button: to set timer function PREPARATION Place the heater wall mounted and can be used in the living room or bed rooms. It is plugged into the 120V 6 0Hz power outlet. -
Page 7: Installation Instruction
INSTALLATION INSTRUCTION Wall MOUNTING INSTALLATION Warning: Check the wall to ensure there is no wiring, pipe wires etc in the area to be drilled. Warning: Do not plug in before wall mounting. Note : The heater cannot be fixed on hollow wall. The heater must be mounted on firm wall. Heater hook position （1）... - Page 8 TABLETOP INSTALLATION (Preparation: Two stand feet and Two 4*25 screws). screws screws Fix the standing leg on the products by using the two 4*25mm screws, as shown in the figure above. Warning: If you choose freestanding use, you don’t need to fix the wall hanging holder on the wall. OPERATING INSTRUCTION 1、Start and select working mode Turn the heater on by pressing the ON/OFF button on the control panel or by...
-
Page 9: Maintenance
2、Setting Desired Temperature Adjust the desired temperature by pressing the Up/Down arrows on the control panel or remote control. Press ℃/℉ button to change the display temperature between Fahrenheit and Celsius. 3、Setting the POWER OFF TIMER Function Note: The Power-Off-Timer Function will allow for the heater to power OFF after a certain set time, and can only be set while the heater’s display is in the “On”... -
Page 10: Troubleshooting
3. To keep the heater clean, the outer shell may be cleaned with a soft, damp cloth. You may use a mild detergent if necessary. After cleaning, dry the unit with a soft cloth. CAUTION: DO NOT let liquid enter the heater. 4. -
Page 11: Limited Manufacturer Warranty
Lifeplus, as the manufacturer). Any extended warranties (warranties that cover above and beyond this manufacturer warranty) that are sold through a retailer or third party, are not directly correlated with this Lifeplus limited warranty, and may be redirected to said retailer or third party for coverage.
Need help?
Do you have a question about the IPH-01 and is the answer not in the manual?
Questions and answers