Nd Mad-Enabled Irf Configuration Example - H3C S5830V2 Configuration Manual

[Sysname-Vlan-interface3] mad arp enable
You need to assign a domain ID (range: 0-4294967295)
[Current domain is: 1]:
The assigned
6. Configure Device E as the intermediate device:
CAUTION:
If the intermediate device is also in an IRF fabric, assign the two IRF fabrics different domain IDs for
correct split detection. False detection causes IRF split.
# Enable the spanning tree feature globally on Device E to prevent loops.
<DeviceE> system-view
[DeviceE] stp global enable
# Create VLAN 3, and assign ports Ten-GigabitEthernet 1/0/1, Ten-GigabitEthernet 1/0/2,
Ten-GigabitEthernet 1/0/3, and Ten-GigabitEthernet 1/0/4 to VLAN 3 for forwarding ARP MAD
packets.
[DeviceE] vlan 3
[DeviceE-vlan3] port ten-gigabitethernet 1/0/1 to ten-gigabitethernet 1/0/4
[DeviceE-vlan3] quit

ND MAD-enabled IRF configuration example

Network requirements
As shown in
Configure ND MAD in the IRF fabric and use the links connected to Device E for transmitting ND
•
MAD packets.
To prevent loops, run the spanning tree feature between Device E and the IRF fabric.
•
domain ID is: 1
Figure 17, set up a four-chassis IRF fabric in the IPv6 enterprise network.
47