Table of Contents
Advertisement
[ENG] NetPing Input+Relay 254R304, User Guide -[ENG] [Input+Relay 254R304] 4. Installation and Connection
[ENG] [Input+Relay 254R304] 4. Installation and Connection
It is forbidden to power the device from both 12V adapter and PoE simultaneously.
In order to connect the device, follow these steps:
1. Remove the
device from its packaging and mount it onto the place you need (or into DIN rail);
2.
Connect the devices which you need (see
and Executive
Devices» section).
3. Power the device from a 12V power supply and connect it to the local network.
default. Fot the initial setting of the device make sure that the address of your computer is located in the same IP-
subnet as the address of the device. For example, the address which is set on the computer can be 192.168.0.11
mask 255.255.255.0.
4.
For the initial configuration of the device parameters using the web-interface, make sure that the device
responds to the ping command at its IP address.
«[ENG] [Input+Relay 254R304] 5. Connection of the External Sensors
[ENG] [Input+Relay 254R304] 4. Installation and Connection
IP address 192.168.0.11 was set by
–
Advertisement
Table of Contents
