Membrane Installation; Hose Connection Scheme - A.O. Smith waterclinic LTS 75 Series User Manual

MEMBRANE INSTALLATION

Ÿ 12" Inline 5 Micron Spun (Sediment) Filter
Ÿ 12" Inline Gac Carbon Cartridge Filter (UDF)
Ÿ 12" Inline Block Carbon Cartridge Filter (CTO)
Ÿ 75 GPD Membran
Ÿ 10" Inline Coconut Post Carbon Filter
• After intalling the filters, unscrew membrane hou
sing cap. Insert the membrane into the housing
until it stops. Then, screw the housing cap.
• Cut the tube to a length that will allow to connect
the post carbon filter outlet to the faucet after
mounting the faucet and drain line.
• Loosen and pull out stem-nut on outlet of
the post carbon filter. Put the nut on tube and
tighten firmly. Insert the other side of the tube
into respectively yellow nut and collet placed
under the faucet. Push the tube to the faucet
and tighten the nut firmly.

HOSE CONNECTION SCHEME

As shown in figure;
Ÿ A: Water inlet
Ÿ B: Product water tube is connected to RO faucet.
Ÿ C: The tube at the outlet of post carbon is
connected to product water line.
Ÿ D: The drain tube is connected to wastewater
outflow line.
12
Yellow nut
Ring
Hose
RO FAUCET
B
Faucet
embodiments
Hose
connection
WASTE
D
WATER
WATER INLET
A