Table of Contents
Advertisement
8. Stand the system up on its
base. Attach the video cable to
both the projector and the
Control Unit. See the photo at
right. (DVI cable shown, HDMI
is an alternate with fairly similar
routing.)
9. Place one of the brightly
colored plastic caps over the
lens mount to keep dust out of
the projector unless you will
immediately install the lens in
the next step.
10.You are now almost ready to
turn on and test your system.
See the section Set Up on
page 6. Once the system is
booted up, make sure your
projector settings are correct
(see Recommended
Projector Settings below).
Disassembly
Should you need to disassemble your Digitarium Zeta system, first shut it down and
unplug it. Then follow the assembly steps in reverse order, as required for your
purposes.
If you need to send your DLP projector to Panasonic for servicing, we recommend that
you remove it from the Digitarium system frame and replace our fisheye lens with the
standard projector lens before doing so.
Digitarium® Zeta Portable User Manual
17
Advertisement
Table of Contents
