Table of Contents
Advertisement
3. Line up the holes in the lens brace with the
mounting holes in the back of the projector. See
photo at right. Place the short screw in the hole
furthest from the lens; use a star washer with this
screw and tighten it fully. Place the shorter spacers
on the three mounting screw holes closest to the
lens, and the longer spacer over the fourth hole.
4. Carefully lower the portable stand frame on top of the spacers so that the screw
holes are aligned with the spacers. See below.
5. Attach the projector to the frame with the 30mm M4 screws and star washers. If
possible, use a drop of threadlocker on each screw.
6. Place the Control Unit on top of the frame. Line up the holes in the Control Unit
flange with the holes in the frame.
7. Use the four 10/32 screws with captive star washers to attach the Control Unit to
the frame. If possible, use a drop of threadlocker on each screw. Push the Control
Unit down toward the frame base so that the screws will go through the smallest
area of the mounting holes. Tighten the screws fully.
Digitarium® Zeta Portable User Manual
16
Advertisement
Table of Contents
