Using Your Appliance With The Control Panel; Overview; Use - Zehnder Rittling Folio Glass Operating Instructions Manual

EN
3. USING YOUR APPLIANCE WITH THE
CONTROL PANEL

3.1 OVERVIEW

The Zehnder radiators are equipped with an advanced control system with
touch-screen controls and light indicators which indicate the set function.
Changes in settings are also remarked by an acoustic signal.
Control panel with symbols and functions:
Touch
Function
screen
T1 STAND-BY
Low-temperature heating
T2
(45°c)
Medium-temperature heating
T3
(55°c)
Maximum-temperature
T4
heating (65°c)
Maximum-temperature
T5
2-hours boost
T6 Keypad Lock
Appliance in tension
Red LED indicates radiator is
heating up
28
LED
T1 L1
L1
L2
T2 L2
L3
T3 L3
L4
L5
T4 L4
L6
L7
T5 L5
L8
T6 L6
L7 L8
IR-receiver
40023222

3.2 USE

When connecting the power supply, all the LEDs light up for
2 seconds and you will hear a long "beep". After this, only L1 and L7
will remain on.
Touch T2 if you wish to heat up the room at low temperature. The L2
and L7 green LEDs will light up and you will hear a "beep". When the
surface of the radiator reaches the set temperature, L8 switches on
and off cyclically in order to maintain the set temperature.
Touch T3 if you wish to heat up the room at medium temperature.
The L3 and L7 green LEDs will light up and you will hear a "beep".
When the surface of the radiator reaches the set temperature, L8
switches on and off cyclically in order to maintain the set temperature.
Touch T4 if you wish to heat up the room at maximum temperature.
The L4 and L7 green LEDs will light up and you will hear a "beep".
When the surface of the radiator reaches the set temperature, L8
switches on and off cyclically in order to maintain the desired tempe-
rature.
Touch the T5 button if you wish to have the maximum surface tem-
perature for a limited time (2 hours), the L5, L7 and L8 LEDs will light
up. The radiator will operate at maximum temperature for 2 hours,
after which, it will go back to operate in the function set before the
Boost function.
If after the settings you wish to lock the keypad, press the T6 button
for 5 seconds - you will hear 4 beeps confirming the setting.
When touching the other buttons lightly, the L6 LED will flash for
2-3 seconds indicating the keypad is currently locked.
Only the T1 button will remain operational, so to put the appliance
on stand-by at any time.
To reactivate the keypad, press the T6 button for 5 seconds -
4 consecutive beeps will confirm the setting.
03/2022
EN
29