JVC FS-G5 Service Manual page 15

3.1.9 Removing the power transformer assembly/ power cord
(See Fig.20 to 24)
• Prior to performing the following procedure, remove the side
panel (R)/(L), the top panel, the main board, the transformer
board, the fan and the amplifier board.
Reference:
You do not need remove the tuner pack which is attached to
the rear panel.
(1) From the back of the body, remove the three screws U at-
taching the rear panel and the rear cover to the base chas-
sis.
(2) Release the two joints e at the lower right and left sides of
the body. The rear panel comes off together with the rear
cover.
(3) From top of the body, remove the four screws Y attaching
the power transformer assembly.
(4) If you disconnect the power cord, pull the power cord stop-
per attaching the power cord in the direction of the arrow as
shown in Fig.24 and remove it from the base chassis.
Rear cover
U
Rear panel
d
Rear panel
Fig.20
Rear cover
Fig.21
Rear cover
Fig.22
Power transformer assembly
Base chassis
Fig.23
Power cord stopper
Power cord
Fig.24
Rear panel
d
Power cord stopper
Y
Power cord
Power cord stopper
Y
Base chassis
(No.MB353)1-15