J1002 Connector - Garmin GTN 725 Maintenance Manual

A.2 J1002 Connector
Pin
1 DEMO MODE SELECT*
2 RESERVED
3 SUSPEND ANNUNCIATE*[1]
4 ETHERNET OUT 4A
5 ETHERNET OUT 4B
6 ETHERNET IN 1A
7 ETHERNET IN 1B
8 ETHERNET OUT 1A
9 ETHERNET OUT 1B
10 SYSTEM ID PROGRAM*[2]
11 GSR STATUS IN* [1]
12 GSR REMOTE POWER OUT*[1]
13 ETHERNET IN 4A
14 ETHERNET IN 4B
15 ETHERNET IN 2A
16 ETHERNET IN 2B
17 ETHERNET OUT 2A
18 ETHERNET OUT 2B
19 RESERVED
20 RESERVED
21 RESERVED
22 RESERVED
23 ETHERNET IN 3A
24 ETHERNET IN 3B
25 ETHERNET OUT 3A
26 ETHERNET OUT 3B
An asterisk (*) following a signal name denotes the signal is an Active-Low, requiring a ground to activate.
If there is no asterisk, the signal is an Active-High.
[1] This discrete may be configured to perform another function. Refer to
GTN 725/750 TSO Installation Manual, P/N 190-01007-02 for more details.
[2] In software version 5.00 or later, the SYSTEM ID PROGRAM* pin is no longer used.
Instead the System ID is set through the System ID settings. Refer to
GTN 725/750 TSO Installation Manual, P/N 190-01007-02 for more details.
190-01007-01
Rev. 5
(View looking at rear of unit, Pin 1 is top right)
9 8 7 6 5 4
18 17 16 15 14 13
26
25 24 23 22 21
Pin Name
1
3 2
J1002
12 11 10
(GTN)
20 19
GTN 725/750 Maintenance Manual
I/O
In
--
Out
Out
Out
In
In
Out
Out
In
In
Out
In
In
In
In
Out
Out
--
--
--
--
In
In
Out
Out
Page A-5