Section C Controls, Gauges And Valves - JackRabbit 30 Manual

SECTION C CONTROLS, GAUGES AND VALVES

1. KEY SWITCH AND IGNITION: Start engine in idle position
2. BELTS CONROL: Rocker Switch "Push ON – Push OFF." Push ON after engine
has started.
REMOTE CONTROL (option): The elevator can be equipped with a remote
control Transmitter and Receiver that allows the JackRunner driver or other
personnel to start, stop, throttle up or down without using the controls on the
elevator. The 30/36 Elevator with this option is equipped with a WARNING
HORN that will sound prior to startup of the belts or WoodChuck.
Keep all personnel clear of belts, WoodChuck fingers and moving parts when
elevator engine is running.
3. THROTTLE SPEED CONTROL – TURTLE = IDLE, RABBIT = FULL SPEED
THROTTLE: Rocker Switch Push TURTLE – Push RABBIT. This switch controls
both belts and the WoodChuck option.
4. & 4A BELT SPEED CONTROL: 4 is hopper belt and 4A is desticker belts. Turn
clockwise to increase belt speed. Turn counter clockwise to decrease belt speed.
This control is normally set and not changed unless there is a significant change in
product characteristics. For best performance do not adjust higher than 7 on flow
control.
5 SELECTOR VALVE: Push handle forward for use of the Hydraulic Jack. Pull
the handle to the rear when the WoodChuck is to be raised to the (out of operation
position) or lowered to the (in service position). Rocker switch 7 will raise or lower
the Jack or WoodChuck.
6. HYDRAULIC JACK: A toggle switch located on frame, near towing hitch will raise
or lower jack. Rocker switch 7 will also raise or lower jack with selector valve in
forward position.
7. JACK or WOODCHUCK: Rocker Switch, Push TOP of switch to raise, Push
BOTTOM to lower.
8. WOODCHUCK (Option): Rocker Switch Push – ON PUSH – OFF. WoodChuck
will only operate when belt control is engaged.
9. KEY – IGNITION LIGHT: The light glows green when the key is in the ON
position.
10. ALTERNATOR WARNING LIGHT: The light glows red when the battery is
discharging.
18