Table of Contents
Advertisement
The following is a list of problems that may occur, and some possible causes and remedies.
If the solution to these problems or any other problem is not readily apparent, contact your
JackRabbit dealer or JackRabbit direct. Phone (209) 599-6118 or Fax (209) 599-6119.
Warning: Do not check for fuel or hydraulic leaks with your hands. The high pressure in
these lines will penetrate the skin and cause serious personal injury.
Problem-symptom
Engine won't start
Engine Stops
Other engine problems
Belts tracking to
one side pulley
WoodChuck
Chain stops
SECTION G TROUBLE SHOOTING
Cause
Dead Battery
Out of fuel
Belt out of
alignment
Stick under chain
Action
Jump start engine. Connect jumper cable to 12
volt auxiliary battery first. Then connect
Positive cable to positive terminal on elevator
battery. Then connect negative cable to frame
of elevator. Connection to frame should not be
near elevator battery.
Fill tank with diesel and bleed air from system.
See Deutz Operation Manual Trouble Shooting
DiagnosticChart.
See Conveyor Belt Adjustment Instruction
Page 17.
Turn engine OFF. Turn chain backwards
with bar. Remove stick and tighten WoodChuck
chain.
Advertisement
Table of Contents
