Controls, Gauges And Valves - JackRabbit YARDJACK Manual

CONTROLS, GAUGES AND VALVES

1. KEY SWITCH AND IGNITION: Start engine in idle position.
2. BELTS CONTROL (Push ON – Push OFF): Push ON after engine has started.
3. THROTTLE SPEED CONTROL: TURTLE = IDLE, RABBIT = FULL
4. LIGHTS: Push ON – Push OFF
5. DIRECTION CONTROL (FORWARD - SIDEWAYS): Rocker Switch push TOP for
forward travel. Push BOTTOM for sideways travel.
6. KEY - IGNITION LIGHT: The light glows green when the key is in the ON position.
7. OIL WARNING LIGHT: The light glows red when oil pressure is low. Engine must
be turned OFF when this light is ON or serious damage to the engine will occur.
8. ALTERNATOR WARNING LIGHT: The light glows red when the battery is
discharging.
9. OIL TEMPERATURE GAUGE: Gauge displays safe and unsafe operating ranges
The engine must be turned OFF if needle is in unsafe operating range or serious damage to
the engine will occur.
10. WOODCHUCK / WINKIE: Toggle the switch up to raise and lower the Winkie and down
to raise and lower the Woodchuck. .
11. WOODCHUCK CONTROL: Push ON – Push OFF
12. CROSS CONVEYER BELT: Controls the direction of the Cross Conveyer belt.
#6
#7
#1
#8
#9
#22
5
#3 #5
#10
#2 #11 #4
#12