Related Manuals for Verkada AX11
Summary of Contents for Verkada AX11
- Page 1 Installation Manual AX11 IO Controller Verkada Inc. 405 E 4th Ave, San Mateo, CA, 94401 All specifications are subject to change without notice. sales@verkada.com Copyright © Verkada Inc . All rights reserved.
-
Page 2: Document Details
This equipment is for use in a restricted access area. Warning Ensure power is disconnected from AX11 while servicing the product or connecting/disconnecting peripherals. Document revision V1.0 Levels of Access Control •... - Page 3 AX11 AC Power LED Behavior Solid Green AC power supplied to controller Verkada Inc. 405 E 4th Ave, San Mateo, CA, 94401 All specifications are subject to change without notice. sales@verkada.com Copyright © Verkada Inc . All rights reserved.
- Page 4 Setup guide, screw pack Accessories Mounting Drywall anchors (M8) and screws (M5) Options Verkada Inc. 405 E 4th Ave, San Mateo, CA, 94401 All specifications are subject to change without notice. sales@verkada.com Copyright © Verkada Inc . All rights reserved.
- Page 5 Once the security screws are fully removed, slide the wall mount down and away from the main enclosure. Verkada Inc. 405 E 4th Ave, San Mateo, CA, 94401 All specifications are subject to change without notice. sales@verkada.com Copyright © Verkada Inc . All rights reserved.
- Page 6 Fasten the two security torx screws to secure the enclosure to the mounting plate. Verkada Inc. 405 E 4th Ave, San Mateo, CA, 94401 All specifications are subject to change without notice. sales@verkada.com Copyright © Verkada Inc . All rights reserved.
-
Page 7: Recommended Wiring
M4 screw. Required Network Settings An Ethernet connection with DHCP must be used to connect the AX11 to the Local Area Network (LAN). You also need to configure firewall settings to communicate with the AX11. • TCP port 443 •... -
Page 8: Connecting Peripherals
Relay Outputs AX11 comes equipped with a Form C relay that can be driven dry. Max DC load: 24V @ 1A, Max DC current = 1A, Max DC voltage = 60VDC. Verkada Inc. 405 E 4th Ave, San Mateo, CA, 94401 All specifications are subject to change without notice. -
Page 9: Connecting An Output
When connecting to an elevator system, it is recommended to wire in a fail safe configuration. Each button’s signal wire should be connected in series with the NC and COM terminal of an AX11 relay output. Wiring a Powered Lock It is recommended to interface with an Access Power Controller to provide power to the accessory. - Page 10 Wiring a Verkada or Wiegand Reader The AX11 is rated to power readers at 12V up to 250mA via the + Vin and - GND connection. The drain wire of the shielded cable should be secured to nearest AX11 grounding point.