Advertisement
Available languages
Available languages
GB
Introduction
Before using the battery charger please read carefully the safety instructions.
This product is suitable for 6V and 12V lead-acid, gel and AGM batteries.
Batteries up to 95Ah could be charged and batteries up to 140Ah maintenance charged.
The charger has several diagnose, protection and recovery features which are proceed fully automatic if the connected
battery requires it. You don't have to take care about anything. These features will elongate your battery life.
Safety instructions
• The charger is designed for charging 6V / 12V lead acid, gel and AGM batteries don't use it for anything else
• Check the cables for damage before you use it
• Never charge a damaged battery
• Don't put the charger on the battery during charging
• Only charge in well vented areas
• Don't cover the battery charger
• There could be explosive gas during charging, you have to avoid sparks
• Battery acid can harm you, if you should have contact with battery acid go immediately to a doctor.
• The charger is not suitable for children or people who can't read and understand the safety instructions. Store it out of the
range of those people or children. Don't let children play with the charger.
Technical details
The LCD display gives you the most important information.
There are several charging modes. You can choose 12V STD for charging 12V lead acid and gel battery, 12V AGM for charging
12V AGM battery and 6V STD for charging 6V lead acid and gel battery. Every mode could be changed into winter mode when
you push the mode button another time the snow flake icon appears and the winter mode is on and you can charge batteries
in low temperatures.
The voltmeter shows the current charging voltage and the battery symbol the current charging status.
There are three icons for malfunctions
Icon left corner shows wrong polarity please change the connection of the clamps
icon in the middle shows defect battery, please let the battery be tested by a mechanic and if necessary change the battery
icon right corner shows bad connection please check the connection between the charger and the battery
Charging
1. Connect the charger to the battery, first the red clamp to plus and then the black clamp to minus
2. Connect the charger to 230V socket
3. Push the mode button to choose the charging mode according to your battery needs
4. The charging will start automatic after a few seconds
5. When the charging is done the display shows FULL and the charger will switch to maintenance mode
2
www.BormannTools.com
Advertisement
