TLW K01-0100 Installation Manual

Galaxy ip44 rated cob led cabinet light 2.6w

Product Name: Galaxy IP44 Rated COB LED Cabinet Light 2.6W

Product Code: K01-0100

Kit Contents

LED cabinet light with micro connector

▪

The rated inputting voltage must be 9 -16V DC. You should use a driver to convert the mains voltage to e 9-

16V DC.

The luminaire shall under no circumstances be covered with insulating material.

During normal use, the object lighted muse not exceed a temperature of 95ºC.

Installation should be carried out by a qualified electrician.

This product may contain substances that can be hazardous to the environment if not disposed of properly.

Electrical and electronic equipment should never be disposed of with household waste.

Cut out diameter is 56mm for cabinet

light.

Each light is fitted with a 2m cable c/w

micro plug. Plug the micro plug into the

driver's connector block (driver may not

be supplied with lights)

If you are blind mounting and want to

conceal the cable and plug, a 8mm

diameter hole is required.

Connect driver to 240V power supply

(driver may not be supplied with lights)

Table of Contents

Do you have a question about the K01-0100 and is the answer not in the manual?

Page 1 Product Name: Galaxy IP44 Rated COB LED Cabinet Light 2.6W Product Code: K01-0100 Kit Contents LED cabinet light with micro connector ▪ Important Safety Information The rated inputting voltage must be 9 -16V DC. You should use a driver to convert the mains voltage to e 9- 16V DC.
Page 2 Product Name: Galaxy IP44 Rated COB LED Cabinet Light 2.6W Product Code: K01-0100 Put the cabinet light in the mounting surface. Other Information Specifications: K01-0100 is a low voltage LED cabinet light, which is 2.6W in wattage and 9-16V DC in rated voltage.